U0503 BMW Fault Code
Check U0503 OBD Fault Code ReasonBMW HO2S Sensor Circuit Malfunction (HO2S-11) During testing the HO2S Heaters are checked for opens/shorts and excessive current draw.
The BMW test fails when current draw exceeds a calibrated limit and/or an open or short is detected. Short to VPWR in harness or HO2S. Water in harness connector. Open VPWR circuit. Open GND circuit. Low battery voltage. Corrosion or poor mating terminals and wiring Damaged HO2S heater. Damaged PCM.
U0503 Code Symptoms :
If your U0503 check engine light is illuminated, it's best to take it in for diagnostic testing, which can feel like a hassle. Because while the lights vary in appearance from vehicle to vehicle, all have the same basic meaning: There's a problem with the car's emissions system. The on-board diagnostics system U0503 and engine control unit are in charge of monitoring a bunch of different , and if they get a reading that's a little out of whack, up pops the check engine light.
Diagnosis And Repairing U0503
U0503 OBD2 specifically refers to the camshaft (cam) timing. In this case, if the cam timing is over-retarded, the engine light will be illluminated and the code will be set.
How to fix U0503 code ?
- Damaged camshaft position (CMP) sensor
- Continuous oil flow to the VCT piston chamber
- Faulty Fuel injector
One example of this would be when an bmw automatic car in placed in gear. To prevent the added drag from the torque converter and transmission from reducing the idling speed, the PCM will command the idle control valve to allow more air to enter the engine, while at the same time, adjusting the injector pulse width to inject more fuel to suit the increased amount of air. Note that the idle air control valve is closed by the PCM when the throttle plate is opened to prevent excess air from entering the engine.
